Transition-networks Standalone Media convertor MGE-PSW-SX-01 User Manual download pdf (Page 2)

M/GE-PSW-xX-01

Tech Support: 1-800-260-1312 International: 00-1-952-941-7600 (24 hours)

Fiber Link/Activity

TP Link/Active

Power ON LED

Fiber Port

Copper Por

Front Panel

Electrostatic Discharge (ESD)

Always observe the following ESD precautions when installing or handing the

M/GE-PSW-xX-01 media converter:

• Do not remove the converter from its protective packaging until you are ready to

install it.

• Wear an ESD wrist grounding strap before handling any module or component. If

you do not have a wrist strap, maintain grounded contact with the system unit

throughout any procedure requiring ESD protection.

Installation

Copper and fiber ports

The illustration below shows the front panel of the M/GE-PSW-xX-01 media

converters.

[email protected] -- Click the “Transition Now” link for a live Web chat.

Installation—Continued

Connect the fiber cable

Full duplex (always ON) is on the fiber side only; therefore, the 512-Bit Rule does not

apply. The cable lengths are constrained by the cable requirement.

1. Locate or build IEEE 803.2™ compliant 1000Base-X fiber cable with male,

two-stranded TX to RX connectors installed at both ends.

2. Connect the fiber cable to the M/GE-PSW-xX-01 media converters as follows:

• Connect the male TX cable connector to the female TX port.

• Connect the male RX cable connector to the female RX port.

3. Connect the fiber cable to the other device (another media converter, hub, etc.)

as follows:

• Connect the male TX cable connector to the female RX port.

• Connect the male RX cable connector to the female TX port.

Note: With AutoCross permanently enabled, the link LED only lights when a valid

end-to-end connection is made.

Connect fiber cable

to media converter

as shown.

Connect fiber cable

to other device

(media converter,

hub, etc.) as shown

1 2 3 4 5 6 7 8 9

No comments

Transition-networks Standalone Media convertor MGE-PSW-SX-01 User Manual Page 2